SUBROUTINES
Subroutines are subprograms that are called from inside another program.
Read the following sections for reference:
- Introduction
- Programming Overview
- Programming G-Code
- Programming G-Code
- Rapid Linear Motion (G00)
- Linear Motion at Feed Rate (G01)
- Arc at Feed Rate (G02 and G03)
- Dwell (G04)
- Set Offsets (G10)
- Plane Selection (G17, G18, G19)
- Length Units (G20 and G21)
- Return to Predefined Position (G28 and G28.1)
- Return to Predefined Position (G30 and G30.1)
- Straight Probe (G38.x)
- Cutter Compensation (G40, G41, G42)
- Dynamic Cutter Compensation (G41.1 and G42.1)
- Apply Tool Length Offset (G43)
- Engrave Sequential Serial Number (G47)
- Cancel Tool Length Compensation (G49)
- Absolute Coordinates (G53)
- Select Work Offset Coordinate System (G54 to G59.3)
- Set Exact Path Control Mode (G61)
- Set Blended Path Control Mode (G64)
- Distance Mode (G90 and G91)
- Arc Distance Mode (G90.1 and G91.1)
- Temporary Work Offsets (G92, G92.1, G92.2, and G92.3)
- Feed Rate Mode (G93, G94, and G95)
- Spindle Control Mode (G96 and G97)
- Programming Canned Cycles
- Programming M-Code
- Programming M-Code
- Supported M-Codes Reference
- Program Stop and Program End (M00, M01, M02, and M30)
- Spindle Control (M03, M04, and M05)
- Tool Change (M06)
- Coolant Control (M07, M08, and M09)
- Automatic Collet Closer Control (M10 and M11)
- Override Control (M48 and M49)
- Feed Override Control (M50)
- Spindle Speed Override Control (M51)
- Set Current Tool Number (M61)
- Set Output State (M64 and M65)
- Wait on Input (M66)
- Programming Input Codes
- Advanced Programming